Archive | IP PBX RSS feed for this section

Caller ID detection of the gateway or VX IPPBX

If the gateway or the VX IPPBX cannot detect the real caller ID, you can refer to the steps below: 1. Please make sure the PSTN line has the function of detecting caller ID: please connect one analog phone with the PSTN line, and then call in the PSTN line, and check if the analog phone […]

Continue Reading Comments { 0 }

Connect two AX100 IPPBX in the LAN

If you want to connect two AX100 in the LAN, I hope the below setting can do help for you. The related information of two AX100 is:   IP address extension Prefix to VOIP account Prefix to another AX100 AX100 1 192.168.1.100 8XXX 00 56 AX100 2 192.168.1.37 7XXX 01 57 We assume that we […]

Continue Reading Comments { 0 }

3CX connects with gateway

Configuring VOPTech VG1X Gateway for 3CX Phone System IMPORTANT This device has been tested for Fax and Voice using firmware ” Rev 1.9.82.297″ versions available. 3CX Support shall require use of the above firmware to address support issues. Please note that you must factory reset the device before starting this procedure to reduce the possibilites […]

Continue Reading Comments { 0 }

Remotely register to VPX IP PBX

If your IP phone in your home wants to register to the VPX in your office, I hope this file can help you. Firstly, let us configure the VPX. logon to VPX browser(http://192.168.1.100:9999); go to System->Management; click the option Show Advanced Options at the bottom of the page; the input box on the left of […]

Continue Reading Comments { 0 }

Multi-site setting of IPPBX

Multi-site usually is used to connect VX and the other VOIP devices, such as another one VX, gateway or elastix. as usual, we just use these option: IP address, Prefix, Area code. Here we connect two VX as an example: VX1:192.168.1.192                                                             VX2: 192.168.1.218 About how to use the Area code, we assume that 12345678 is […]

Continue Reading Comments { 0 }